This is a development board with a Philips LPC2148 ARM processor. This chip has 512Kb Flash, 42Kb RAM, an RTC, 4 10-bit ADC inputs, 2 UARTs, I2C, SPI, 2 32bit timers, 7 CCRs, 6 PWM, WDT, 5V tolerant I/O. With the 12 MHz crystal it can run (from RAM) at up to 60 MHz. It has a Wiggler-compatible JTAG interface, a reset button, and a status LED. It has a serial interface that can be used for bootloading with the Philips bootloader, and/or or for serial communcation. The board has a prototype area. The I/O pins of the ARM chip are available on two pinstrips.
The board can be powered from the USB connector, or from a 6V DC or AC wall-wart. The board itself consumes less that 100 mA.
manufacturer: Olimex
Related products: |
ARM-USB-JTAG | USB JTAG interface for ARM development boards |
|
ARM-USB-TINY-JTAG | USB JTAG interface for ARM development boards |
|
ARM-USB-EW-JTAG | USB JTAG interface for ARM development boards |
|
ARM-PAR-JTAG | parallel port JTAG interface for ARM development boards |
|
ST-LINK-01 | ST link STM32 programmer clone |
|
DB100 | DB100 LPC USB serial downloader |
|
MOD-I2C-SHIFT-01 | I2C level shifter board |