This is a development board with a Philips LPC2129 ARM processor. This chip has 256Kb Flash, 16Kb RAM, an RTC, 4 10-bit ADC inputs, 2 UARTs, 2 CAN interfacesI2C, SPI, 2 32bit timers, 7 CCRs, 6 PWM, WDT, 5V tolerant I/O. With the 14.7456 MHz crystal it can run (from RAM) at up to 58.9824 MHz. It has a Wiggler-compatible JTAG interface, a reset button, and a status LED.
The board has a CS8900A Ethernet interface and a 24LC515 64k * 8 EEPROM, which can for instance store a served web page. The board has an FT232 USB-to-serial interface, which can be used for bootloading with the Philips bootloader, and/or or for serial communcation.
The I/O pins of the ARM chip are available on an extension header.
The board is powered via the USB interface. If you do not want to connect it to a PC or hub you must supply 5V via the USB connector.
manufacturer: Olimex
Related products: |
ARM-USB-JTAG | USB JTAG interface for ARM development boards |
|
ARM-USB-TINY-JTAG | USB JTAG interface for ARM development boards |
|
ARM-USB-EW-JTAG | USB JTAG interface for ARM development boards |
|
ARM-PAR-JTAG | parallel port JTAG interface for ARM development boards |
|
ST-LINK-01 | ST link STM32 programmer clone |
|
DB100 | DB100 LPC USB serial downloader |
|
MOD-I2C-SHIFT-01 | I2C level shifter board |